Elementum 16 Poly Grip

Product Information

Elementum 16 Poly Grip Coating is a two-part Polyurethane, aerogel matrix and come in a clear or any colour. It is a uniquely hard, hydrophobic, and durable coating, which demonstrates unsurpassed semi-gloss and colour retention, as well as chalk resistance when used in exterior applications. It is resistant to water and humidity, stains, acid splash, solvents, and chemicals. It has a tremendous scuff, mark, and impact resistance. It is a self- levelling coating.

Typical uses

Architectural solutions; Maintenance that require utmost in exterior durability; as a topcoat for Elementum Rust Protector and Elementum Moist Grip; Floor covering where a tough, long-lasting finish is required; exceptionally good alkali and acid resistance; anywhere a solvent based UV resistant topcoat is required; easy to clean; always dry.

Application Method

Elementum 16 Poly Grip can be used on metal, concrete, masonry, wood, and other substrates. The application can be done by brush, roller, or airless spray gun.

  • Note: Do not coat within 50mm of chlorinated rubber paint.
  • Note: Never use mineral spirits to prep or thin the product.
  • Porous Surfaces: Apply one coat to absorb into the substrate. Apply additional coat 150 microns wet to 75microns dry, each application. Coverage: 5m²/litre.
  • Non-Porous Surfaces: Apply one coat of Elementum Poly Grip 150 micron wet/75micron dry as an architectural coating, apply another coat where you may have machine and foot traffic, like floors, handrails etc. Coverage: 4m²/Litre. (75 micron dry)

    WARNING

    USE ONLY AMOUNT NEEDED FOR APPLICATION. ONCE OPENED USE IMMEDIATLEY SINCE PRODUCT CURES FAST

    Directions of Use

  • Mix well before use. Very well!
  • Only pour out the amount of paint needed, and put a piece of plastic on top of paint before closing the lid.
  • Do not leave paint can open for extended periods of time.
  • Ensure surface is clean, oil free and dry.
  • Can be applied with a spray gun, brush or roller.
  • First coat cover, IF second coat is needed, it MUST be applied within one hour.
  • Touch dry after 20 minutes
  • Full Curing Time: 21 Days

    Safety Precautions

    Do not use this product without first taking all appropriate safety measures. (Refer to Safety Data Sheet) Keep out of reach of children. Limitation of liability: The information in this data sheet is based upon tests that we believe to be accurate and is intended for guidance only. Dry Tech Aerogels have no control over either quality or condition of the substrate affecting the use of the product, therefor Dry Tech Aerogels does not accept any liability arising from loss, injury or damage resulting from such use for the contents of this data sheet.

  • Address

    Afrox Business Park

    11 Delfos Blvd, NW7,

    Vanderbijlpark, 1900

    South Africa

    Contact

    info@dry-tech.co.za

    +27 16 931 1640

    Mondays - Fridays 8am - 5pm